Manualshelf

Quick Start Manual

ManualsBrandsNetgear ManualsHubsNetgear GS716Tv1
21222324252627282930
23
GS716T/GS724T Gigabit Smart Switch
Step 6: Apply AC Power
NETGEAR Smart Switch does not have an ON/OFF switch. The method of applying or
removing AC power is by connecting or disconnecting the power cord. Before connecting the
power cord, select an AC outlet that is not controlled by a wall switch, which can turn off
power to the switch. After selecting an appropriate outlet, use the following procedure to
apply AC power.
1. Connect the female end of the supplied AC power adapter cable to the power receptacle
on the back of the switch.
2. Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC
outlet.
When applying power, the Power LED on the switch’s front panel is Green.
If the Power LED does not go on, check that the power cable is plugged in correctly and that
the power source is good. If this does not resolve the problem, refer to
Appendix A
.