User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure System Information User Manual94
14. From the Timer Schedule menu, select a timer schedule or select None, which is the
default selection.
For information about setting up and configuring PoE timer schedules, see
Set up PoE
timer schedules on page 126.
15. Click the Apply
button.
Your settings are saved.
The following table describes the nonconfigurable fields on the page.
Table 17. PoE Port Configuration
Field Description
High Power All ports supports high power mode.
Max Power (mW) The maximum power in milliwatts that can be provided by the port.
Class The class defines the range of power that a powered device (PD) is drawing from
the switch.
The class definitions are as follows:
•
0.
0.44–16.2W
•
1. 0.44–4.2W
• 2. 0.44–7.4W
• 3. 0.44–16.2W
• 4. 0.44–31.6W
• Unknown. The class cannot be detected, or no PD is attached to the port.
Output Voltage (Volts) The voltage that is delivered to the PD in volts.
Output Current (mA) The current that is delivered to the PD in mA.
Output Power (mW) The power that is delivered to the PD in mW.
Status The operational status of the port. The possible values are as follows:
• Disabled.
No
power is delivered.
• Delivering Power. Power is being drawn by the PD.
• Requesting Power. The port is requesting power.
• Fault. A problem occurred with the power.
• Searching. The port is not in one of the other states in this list.