User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Maintain or Troubleshoot the Switch User Manual405
Send an IPv4 traceroute
You can configure the switch to send a traceroute request to a specified IPv4 address or host
name. You can use this to discover the paths that packets take to a remote destination.
When you send a traceroute, the switch displays the results below the configurable data.
If a reply to the traceroute is received, the following message displays:
traceroute to x.y.z.w (x.y.z.w), maxTTL hops max, size byte packets
initTTL x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+1 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+2 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
To send an IPv4 traceroute:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 17 or Access the switch off-network and not
connected to the Internet on page 25.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 28.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 26.
5. Click the Go
button.
The System Information page displays.
6. Select Maintenance >
Troubleshooting > Traceroute IPv4.