User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Monitor the System User Manual380
7. Select an Admin Mode radio button:
• Disable. Port mirroring is disabled. This is the default setting.
• Enabled
. Port mirroring is enabled.
8. From
the Destination Port menu,
select the physical destination port to which port traffic
must be copied.
You can configure one destination port only. The port functions as a probe port and
receives traffic from all configured source ports. If no port is configured, None is
displayed.
The default is None.
9. Click the Apply
button.
Your settings are saved.
In the Source Interface Configuration section, perform the following steps.
10. Select
whether to display physical interfaces, LAGs, the CPU, or al by clicking one of the
following links
above the table heading:
•1 (the
unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
• LAG
. Only LAGs are displayed.
• CPU. Only the CPU is displayed.
• All.
The physical interfaces, LAGs, and CPU are displayed.
11. Select one
or more interfaces by taking one of the following actions:
• To select a single interface, select the check box associated with the port, or type the
port number in the Go T
o Interface field and click the Go button.
• To select multiple interfaces, select the check box associated with each interface.
Traf
fic from the selected ports will be sent to the destination port.