User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Monitor the System User Manual369
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 17 or Access the switch off-network and not
connected to the Internet on page 25.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 28.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network locat
ion.
For information about the credentials, see
Credentials for the device UI on page 26.
5. Click the Go
button.
The System Information page displays.
6. Select Monitoring > Ports
> Cable Test.
7. Select one or more interfaces by taking one of the following actions:
• To test a single interface, select the check box associated with the port, or type the
port number in the Go To Interface
field and click the Go button.
• To test multiple interfaces, select the check box associated with each interface.
• To test all interfaces, select the check box in the heading row.
8. Select the check boxes that are associated with the physical ports for which you want to test
the
cables.
9. Click the Apply
button.
A cable test is performed on all selected ports. The cable test might take up to two
seconds to complete. If the port forms an active link with a device, the cable status is
always Normal. The
test returns a cable length estimate if this feature is supported by the
physical layer (PHY) for the current link speed. Note that if the link is down and a cable is
attached to a 10/100 Ethernet adapter then the cable status might be Open or Short
because some Ethernet adapters leave unused wire pairs unterminated or grounded.