User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Manage Device Security User Manual315
The previous figure does not show all columns.
7. From the ACL
Name menu, select the MAC ACL.
8. In the Sequence
Number field, enter a number in the range from 1 to 2147483647 to
identify the rule.
9. From the Action
menu, select the action that must be taken if a packet matches the rule’s
criteria:
• Permit. Forwards packets that meet the
ACL criteria.
•
Deny. Drops packets that meet the ACL criteria.
10. In the Assign
Queue field, specify the hardware egress queue identifier that must be used
to handle all packets matching this ACL rule.
The range for the queue ID is from 0 to 7.
11. From the Mirror
Interface menu, select the specific egress interface to which the matching
traffic stream must be copied, in addition to being forwarded normally by the switch.
You cannot configure this option if you already configured a redirect interface
for the ACL
rule. This field is visible for a Permit action.
12. From the Redirect Interface menu, select the egress interface to which the matching traffic
stream must be redirected, bypassing any forwarding decision normally performed by the
switch.
You cannot configure this option if you already configured a mirror interface for the ACL
rule.
13. From the Match
Every menu, select whether each Layer 2 MAC packet must be matched
against the rule:
• True. Each packet must match the selected
ACL rule.
•
False. Not all packets need to match the selected ACL rule.
14. In the CoS
field, specify the 802.1p priority that must be compared against the information in
an Ethernet
frame.
The range for the priority is from 0 to 7.
15. In the Destination
MAC field, specify the destination MAC address that must be compared
against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC address of 01:80:C2:xx:xx:xx.
16. In the Destination
MAC Mask field, specify the destination MAC address mask that must
be compared against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC mask of 00:00:00:ff:f
f:ff.
17. From the EtherType Key menu, select the EtherType value that must be compared against
the information in an Ethernet frame.