User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Switching User Manual196
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 17 or Access the switch off-network and not
connected to the Internet on page 25.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 28.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network locat
ion.
For information about the credentials, see
Credentials for the device UI on page 26.
5. Click the Go
button.
The System Information page displays.
6. Select Switching > Multicast
> IGMP Snooping Querier > Querier Configuration.
7. Configure the following settings:
• Querier Admin Mode. Enable or
disable IGMP snooping for the switch. The default is
Disable.
• Snooping Querier IP Address. Enter the
snooping querier IP address to be used as
the source address in periodic IGMP queries. This address is used when no address
is configured on the VLAN on which a query is being sent.
• IGMP Version. Specify the IGMP protocol version used in periodic IGMP queries.
The range is 1 to 2. The default value is 2.
• Query
Interval (secs). Specify the
time interval in seconds between periodic queries
sent by the snooping querier. The query interval must be in the range from 1 to 1800.
The default value is 60 seconds.
• Querier Expiry Interval (secs). Specify the time interval in seconds after which the
last querier information is removed. The querier expiry interval must be in the range
from 60 to 300.
The default value is 125 seconds.
8. Click the Apply button.
Your settings are saved.