User Manual

16-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Switching User Manual151
The following table describes the nonconfigurable information on the page.
Table 25. VLAN status
Field Definition
VLAN ID The VLAN identifier (VID) of the VLAN. The range of the VLAN ID is 1 to 4093.
VLAN Name The name of the VLAN. VLAN ID 1 is always named Default.
VLAN Type The VLAN type:
Member Ports The ports that are included in the VLAN.
Configure the port PVID settings
You can assign a port VLAN ID (PVID) to an interface. The following requirements apply to a
PVID:
• By default, the PVID for each port is 1.
• If you do not specify another value, the default VLAN PVID is used.
• To change the port’s default PVID, you must first create a VLAN that includes the port as
a member (see
Configure VLAN membership on page 148).
To configure PVID settings:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 17 or Access the switch off-network and not
connected to the Internet on page 25.
• Default (VLAN ID = 1). Always present.
• Auto-VoIP (VLAN ID = 4088). Always present.
• Static. A VLAN that you configured.
• Dynamic. A VLAN that is created through GVRP registration, that you did not convert to
a static VLAN, and that GVRP can therefore remove.