User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Monitor the System User Manual372
• Informational (6). Informational messages. This is the default setting.
• Debug (7). Debug-level messages.
Note: A log records messages equal to or above a configured severity threshold.
10. Click the Apply
button.
Your settings are saved.
The Memory Log table displays on the Memory Log page.
The Total number of Messages field displays the number of messages
the
system logged
in memory. Up to 450 of the most recent entries can be displayed.
The rest of the page displays the Memory Log messages. The format of the log message
is the same for messages that are displayed for the message log, persistent log, or
console log. Messages logged to a collector or relay through syslog support the same
format as well.
The following example shows the standard format for a log message:
*Jan 01 2018 00:00:18: AAA-5-CONNECT: New http connection for user
admin, source 192.168.1.111 ACCEPTED
The message was generated by component AAA on January 1, 2018 at 00:00:18 a.m.
with severity 5 (Notice). The message indicates that the admini
strator logged on to the
HTTP management interface from a host with IP address 192.168.1.111.
11. To refresh the page with the latest information about the switch, click the Refresh
button.
12. To clear the messages from the buffered log in the memory, click the Clear
button.
Manage and view the flash log
The flash log is a persistent log, that is, is a log that is stored in persistent storage. Persistent
storage survives across platform reboots. The first log type is the system startup log. The
system startup log stores the first 32 messages received after system reboot. The second log
type is the system operation log. The system operation log stores messages received during
system operation.
To manage and view the flash log:
1. Connect
your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 18 or Access the switch off-network on page 27.