User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Quality of Service User Manual232
policy supports a single data rate and results in one of two outcomes: conform or
violate. Packets that violate the policy are always dropped. That is, you cannot specify
any other action for those packets. You must specify a policy action for packets that
conform to the policy.
- Committed Rate. Enter the committed rate that is applied to conforming packets
by specifying a value in the range from 16 to 1000000 Kbps.
- In the Conform
Action section, select
one of the following radio buttons:
• Send. Packets are forwarded unmodified. This is the default confirming action.
•
Drop. Packets are dropped. This is the default (and only) violating
action.
• Mark CoS. Packets are marked by DiffServ with the specified CoS value
before
being forwarded. This selection requires that the Mark CoS field is set.
You must select a CoS value from 0 to 7 from the menu.
• Mark IP Precedence. These
packets are marked by DiffServ with the specified
IP Precedence value before being forwarded. This selection requires that the
Mark IP Precedence field is set. You must select an IP precedence value from
0 to 7 from the menu.
• Mark IP DSCP.
Packets
are marked by DiffServ with the specified DSCP value
before being forwarded. This selection requires that the DSCP field is set. You
must either select a DSCP code from the menu or enter an IP DSCP value
from 0 to 63 in the field next to the menu. A value that you enter in the field
overrides any selection from the menu.
The DSCP value is defined as the high-order six bits of the Service
T
ype octet
in the IP header.
12. Click the Apply
button.
Your settings are saved.
Rename an existing DiffServ policy
To rename an existing DiffServ policy:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 18 or Access the switch off-network on page 27.
The Local Device Login page displays.
If you did not yet register the switch
with your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register the switch on page 31.