User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Get Started User Manual23
10. Write down the switch IP address assigned by the DHCP server.
For information about how to access the local browser UI of the switch, see
Access the
switch on-network when you know the switch IP address on page 26.
Tip: After you complete the initial log-in process (see
Register the switch
on page 31), you can access the local browser UI from the Switch
Discovery Tool by clicking the ADMIN PAGE button next to your
switch.
Discover the switch in a network with a DHCP server
using the Smart Control Center
This section describes how to set up your switch in a network that includes a DHCP server.
The DHCP client on the switch is enabled by default. When you connect the switch to your
network, the DHCP server automatically assigns an IP address to the switch. Use the Smart
Control Center (SCC) to discover the IP address automatically assigned to the switch.
For information about the SCC, visit
https://www.netgear.com/support/product/SCC.
To install the switch in a network with a DHCP server:
1. Connect the switch
to a network with a DHCP server.
2. Power on the switch by connecting its power cord.
3. Install the SCC on your computer.
4. Start the SCC.
5. Click the Discover
button for the SCC to discover all the devices in the subnet.
6. Write down the switch IP address assigned by the DHCP server.
For information about how to access the local browser UI of the switch, see
Access the
switch on-network when you know the switch IP address on page 26.