User Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Configure Switching User Manual146
10. In the LAG table, click each LAG once, twice, or three times to configure one of the following
modes or reset the LAG to the default settings:
• T (Tagged).
Selects the
LAG as a tagged LAG in the VLAN. All frames transmitted on
the LAG are tagged for this VLAN.
• U (Untagged). Selects the LAG as an untagged LAG in the VLAN. All frames
transmitted on the LAG are untagged for this VLAN.
• Blank
. The LAG is excluded from the VLAN.
11. Click the Apply
button.
Your settings are saved.
The following table describes the nonconfigurable information on the page.
Table 23. Advanced VLAN membership
Field Definition
VLAN Name The name for the VLAN that you selected. It can be up to 32 alphanumeric characters long,
including blanks. The names for the following VLANs are predefined:
VLAN
Type The type of the VLAN you selected:
View the VLAN status
You can view the status of all currently configured VLANs.
To view the VLAN status:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 18 or Access the switch off-network on page 27.
The Local Device Login page displays.
If you did not yet register the switch with
your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register the switch on page 31.
• VLAN 1. Default.
• VLAN 4088. Auto-VoIP.
• Default (VLAN ID
= 1). Always present.
• Static. A VLAN that you configured.
• Dynamic. A VLAN that is created through GVRP registration, that you did not convert to
a static VLAN, and that GVRP can therefore remove.