User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure System Information User Manual84
The range is 3,000–30,000 mW. The default is 30,000 mW.
12. From the Detection Type menu, select how the port detects the attached PD:
•
IEEE 802. The port performs a 4-point resistive detection.
This is the default setting.
• 4pt 802.3af + Legacy. The port performs a 4-point resistive detection, and if required,
continues with legacy detection.
•
Legacy. The port performs legacy detection.
13. From the Timer
Schedule menu, select a timer schedule or select None, which is the
default selection.
For information about setting up and configuring PoE timer schedules, see
Set up PoE
timer schedules on page 123.
14. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable fields on the page.
Table 25. PoE Port Configuration
Field Description
High Power All ports supports high power mode.
Max Power (mW) The maximum power in milliwatts that can be provided by the port.
Class The class defines the range of power that a powered device (PD) is drawing from
the switch.
The class definitions are as follows:
• 0: 0.44–16.2W
• 1: 0.44–4.2W
• 2: 0.44–7.4W
• 3: 0.44–16.2W
• 4: 0.44–31.6W
• Unknown
.
The class cannot be detected, or no PD is attached to the port.
Output V
oltage (Volts) The voltage that is delivered to the PD in volts.
Output Current (mA) The current that is delivered to the PD in mA.
Output Power (W) The power that is delivered to the PD in watts.
Status The operational status of the port. The possible values are as follows:
• Disabled. No power is delivered.
• Delivering
Power. Power is being drawn by the PD.
• Requesting
Power. The port is requesting power.
• Fault. A problem occurred with the power.
• Test. The port is in test mode.
• Other Fault. The port is idle because of an error condition.
• Searching. The port is not in one of the other states in this list.