User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure System Information User Manual65
If you do not know the IP address of the switch, see Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password
field.
The default password is password.
The System Information page displays.
5. Select System > Management > Denial of Service >
Auto-DoS Configuration.
The
Auto-DoS Configuration page displays.
6. Select the Auto-DoS Mode Enable
radio button.
When an attack is detected, a warning message is logged to the buffered log and is sent
to the syslog server.
At the same time, the port is shut down and can be enabled only
manually by the admin user.
7. Click the Apply button.
Your settings are saved.
Configure denial of service
The Denial of Service Configuration page allows you to select which types of DoS attacks the
switch monitors and blocks.
To configure individual DoS settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password
field.
The default password is password.
The System Information page displays.
5. Select System > Management > Denial of Service > Denial of Service Configuration.