User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Maintain or Troubleshoot the Switch User Manual444
• IP Address. The source IP address that must be used for the traceroute. With this
selection, the IPv6 Address field displays and you must enter the IPv6 address that
must be used as the source.
• Interface. The interface that must be used for the traceroute. With this selection, the
Interface
menu displays and you must select an interface as the source.
15. Click the Apply button.
A traceroute request is sent to the specified IP address or host name. The results are
displayed below the configurable data in the Results field.
Enable remote diagnostics
For enhanced security the remote diagnostic option is disabled by default. You can enable
option to access the switch remotely. When remote access is enabled, you or technical
support can perform remote diagnostics services.
To enable remote diagnostics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of the
switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password
field.
The default password is password.
The System Information page displays.
5. Select Maintenance > T
roubleshooting > Remote Diagnostics.
The Remote Diagnostics page displays.
6. Select the Enable
radio button.
7. Click the Apply button.
Your settings are saved.