User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure Routing User Manual221
The default password is password.
The System Information page displays.
5. Select Routing > IP > IP Configuration.
6. Select the Routing Mode Enable radio button.
You must enable routing for the switch before you can route through any of the
interfaces. Routing is also enabled or disabled per VLAN interface. The default value is
Disable.
7. Click the Apply button.
Y
our settings are saved.
The following table describes the IP configuration information displayed on the page.
Table 57. Global IP status information
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol. The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch.
This is a compile-time
constant.
The default value is 1.
View the IP routing statistics
You can view the IP routing statistics as specified in RFC 1213.
To view the IP routing statistics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password field.