User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure Switching User Manual207
Configure an MVR group
To configure an MVR group:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is
password.
The System Information page displays.
5. Select Switching > MVR >
Advanced > MVR Group Configuration.
6. In the MVR Group IP field, specify the IP address for the new MVR group.
7. In the Count field, specify the number of contiguous MVR groups.
This number helps you to create multiple MVR groups through a single click of the Add
button. If the field is empty
, then clicking the button creates only one new group. The field
is displayed as empty for each particular group.
The range is from 1 to 256.
8. Click the Add button.
The MVR group is added.
The following table describes the nonconfigurable information displayed on the page.
Table 53. MVR Group Configuration
Field Definition
Status The status of the specific MVR group.
Members The list of ports that participate in the specific MVR group.