User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure Switching User Manual199
8. In the Membership Interval field, set the value for the group membership interval of MLD
snooping for the specified VLAN ID.
The valid range is Maximum Response Time + 1 to 3600.
9. In the Maximum Response Time
field, set the value for the maximum response time of
MLD snooping for the specified VLAN ID.
The valid range is 1 to Group Membership Interval –1. This value must be less than the
group membership interval value.
10. In the Multicast Router Expiry Time
field, set the value for the multicast router expiry time
of MLD snooping for the specified VLAN ID.
The valid range is 0 to 3600.
11. Click the Add button.
MLD snooping is enabled on the specified VLAN.
12. Click the Apply button.
Your settings are saved.
Modify the MLD snooping settings for a VLAN
To the modify MLD snooping settings for a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password
field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > MLD VLAN Configuration.
The MLD VLAN Configuration page displays.
6. Select the check box next to the VLAN ID.
7. Change the settings.
8. Click the Apply button.
Your settings are saved.