User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
Configure Switching User Manual181
The following table describes the MFDB Statistics fields.
Table 46. MFDB Statistics information
Field Description
Max MFDB Table Entries The maximum number of entries that the Multicast Forwarding Database
table can hold.
Most MFDB Entries Since Last
Reset
The largest number of entries that were present in the Multicast Forwarding
Database table since last reset.
This value is also known as the MFDB
high-water mark.
Current Entries The current number of entries in the Multicast Forwarding Database table.
Configure the auto-video multicast settings
You can configure the auto-video multicast settings.
To configure auto-video multicast settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is
password.
The System Information page displays.
5. Select Switching> Multicast >
Auto-Video
.
The Auto-Video Configuration page displays.
6. Select one of the following radio buttons:
• Select the Disable radio button to globally disable Auto-Video administrative mode
for the switch.
• Select the Enable radio button to globally enable Auto-Video administrative mode for
the switch.
The
Auto-Video VLAN field shows the number of autoconfigured IGMP snooping VLANs.
7. Click the Apply button.
Your settings are saved.