User Manual

S350 Series 8-Port Gigabit Ethernet Smart Switch Models GS308T and GS310TP
Maintenance User Manual325
Change the Software Image That Loads When the Switch Starts or Reboots
To change the image that loads during the boot process:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Discover or Change the Switch IP
Address on page 12.
Your web browser might display a security message, which you can ignore. For more
information, see Access the Local Browser Interface on page 18.
The login window opens.
4. Enter the switch’s password in the Password
field.
The default password is password.
The System Information page displays.
5. Select Maintenance > File Management > Dual Image Configuration.
6. From the Image Name menu, select the image that is not the image displayed in the
Current-active field but that is the image that you want the switch to run after it reboots.
The Current-active field displays the name of the active image.
7. As an option, specify a name for the selected image by entering one in the Image
Description field.
8. Select the Activate Image check box.
9. Click the Apply button.
Your settings are saved.
IMPORTANT:
After activating an image, you must reboot the switch. Otherwise,
the switch continues running the image shown in the Current-active
field until the switch reboots.