User Manual

S350 Series 8-Port Gigabit Ethernet Smart Switch Models GS308T and GS310TP
Monitor the System User Manual311
6. Select an Admin Mode radio button:
• Disable. Port mirroring is disabled. This is the default setting.
•
Enabled. Port mirroring is enabled.
7. From the Destination Port menu, select the physical destination port to which port traf
fic
must be copied.
Y
ou can configure one destination port only. The port functions as a probe port and
receives traffic from all configured source ports. If no port is configured, None is
displayed.
The default is None.
8. Click the Apply button.
Your settings are saved.
In the Source Interface Configuration section, perform the following steps.
9. Select whether to display physical interfaces, LAGs, the CPU, or al by clicking one of the
following links above the table heading:
•1
(the unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
•
LAG. Only LAGs are displayed.
• CPU. Only the CPU is displayed.
• All.
The physical interfaces, LAGs, and CPU are displayed.
10. Select one or more interfaces by taking one of the following actions:
• To select a single interface, select the check box associated with the port, or type the
port number in the Go T
o Interface field and click the Go button.
• To select multiple interfaces, select the check box associated with each interface.
T
raffic from the selected ports will be sent to the destination port.