User Manual

S350 Series 8-Port Gigabit Ethernet Smart Switch Models GS308T and GS310TP
Monitor the System User Manual305
- Alert (1). The second-highest warning level. An alert log message is saved if a
serious device malfunction occurs, such as all device features being down. Action
must be taken immediately.
- Critical (2).
The third-highest warning level. A critical log message is saved if a
critical device malfunction occurs, for example, two device ports are not
functioning, while the rest of the device ports remain functional.
- Error (3).
A device error occurred, such as a port being offline.
- Warning (4).
The lowest level of a device warning.
- Notice (5). Normal but significant conditions. Provides the network administrators
with device information.
- Informational (6). Provides device information.
- Debug (7). Provides detailed information about the device.
8. From the Logs to be Displayed menu, select one of the following options:
• Current Logs.
The log messages for the current switch session are displayed. This is
the default setting.
• Previous Logs.
The previous log messages are displayed, that is, the log messages
that are still in the flash memory from before the switch was rebooted.
9. Click the Apply button.
Your settings are saved.
The Total Number of Messages field shows is the total number of persistent log
messages that are stored on the switch.
The maximum number of persistent log
messages displayed on the switch is 64.
*Jan 01 2018 00:00:18: AAA-5-CONNECT: New http connection for user
admin, source 192.168.1.111 ACCEPTED
The message was generated by component AAA on January 1, 2018 at 00:00:18 a.m.
with severity 5 (Notice).
The message indicates that the administrator logged on to the
HTTP management interface from a host with IP address 192.168.1.111.
Manage the Server Log
You can let the switch send log messages to remote logging hosts. A remote log server is the
same as a remote syslog host.
You must enable the server log on the switch and specify one or more remote syslog hosts.
Enable the Server Log and Add a Remote Syslog Host
To enable the server log and add a remote syslog host:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.