User Manual

Table Of Contents
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure System Information User Manual95
The System Information page displays.
6. Select System > PoE > Advanced > PoE Port Configuration.
The previous figure shows the PoE Port Configuration page for model GS110TPv3.
The delivered power is stated in the Output Power (mW) column.
Activate the new PoE budget for an optional or
replacement power adapter (model GS110TPP)
Model GS110TPP supports NETGEAR FlexPoE power. This feature allows for an
interchangeable power adapter so that you can change your PoE power budget.
Model GS110TPP comes with a 130W power adapter that provides a PoE power budget of
120W.
If you purchase and connect the NETGEAR optional power adapter model EPS200W, you
can upgrade the PoE power budget to 190W. After you change the power adapter, you must
use the device UI to activate the new power adapter that you connected to the switch.
Note: If you do not change the power adapter, you do not need to select the
PoE budget and power adapter in the device UI. By default, the 130W
power adapter is selected, and model GS110TPP provides a PoE
power budget of 120W.
Perform the following task after you disconnect the old power adapter from the switch,
connect the new power adapter to the switch, and start the switch.
To activate the new PoE budget for an optional or replacement power adapter on
model GS110TPP:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.