User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure System Information User Manual58
8. Click the Apply button.
Your settings are saved.
Configure the IP network settings for
management access
You can configure network information for the device UI, which is the logical interface used
for in-band connectivity with the switch through any of the switch’s front-panel ports. The
settings associated with the device UI do not affect the configuration of the front panel ports
through which traffic is switched or routed.
Configure the IPv4 network and VLAN settings for the
device UI
You can configure the IPv4 network information for the device UI, which is the logical
interface used for in-band connectivity with the switch through any of the switch’s front-panel
ports.
To configure the IPv4 network and VLAN settings for the device UI:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 20 or Access the switch off-network and not
connected to the Internet on page 28.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 31.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 29.
5. Click the Go
button.