User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual325
8. Click the Apply button.
Your settings are saved. By default, the access profile is deactivated. After
you add rules,
you can activate the access profile.
Add a rule to the access profile
After you add the access profile, you can add one or more security access rules to the
access profile.
If you access the switch from a computer, make sure that you add a permit rule for the type of
service that you use (for example, HTTPS), your computer’s IP address, and your
computer’s subnet mask.
CAUTION:
You must add a permit rule for your device and access method, otherwise
you are locked out from the switch after you activate the access profile. If
that situation occurs, you must reset the switch to factory default settings
(see
Reset the switch to its factory default settings on page 433).
To add a rule to the access profile:
1. Connect
your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 20 or Access the switch off-network and not
connected to the Internet on page 28.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 31.
4. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight app or
Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the device UI on page 29.
5. Click the Go
button.
The System Information page displays.
6. Select Security >
Access > Access Control > Access Rule Configuration.