User Manual

Table Of Contents
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Quality of Service User Manual262
By default, the Global radio button is selected.
To configure the same CoS trust mode settings for all CoS configurable interfaces, do
the following:
a. Select the Global
radio button.
b. From the Global
Trust Mode menu, select one of the following trust mode
options for ingress traffic on the switch:
- Untrusted. Do not trust any CoS packet marking at ingress.
- 802.1p. The eight priority tags that are specified in IEEE 802.1p are
p0 to p7.
The QoS setting lets you map each of the eight priority levels to one of eight
internal hardware priority queues. The default mode is 802.1p.
- DSCP. The six most significant bits of the DiffServ field are called the
Dif
ferentiated Services Code Point (DSCP) bits.
To configure CoS settings per interface, do the following:
a. Select the Interface
radio button.
b. From the Interface
Trust Mode menu, select one of the following trust mode
options:
- Untrusted. Do not trust any CoS packet marking at ingress.
- 802.1p. The eight priority tags that are specified in IEEE 802.1p are
p0 to p7.
The QoS setting lets you map each of the eight priority levels to one of seven
internal hardware priority queues. The default mode is 802.1p.
- DSCP. The six most significant bits of the DiffServ field are called the
Dif
ferentiated Services Code Point (DSCP) bits.
8. Click the Apply
button.
Your settings are saved.
Configure the CoS settings for an interface
You can configure the trust mode for one or more interfaces and apply an interface shaping
rate to all interfaces or to a specific interface.
To configure the CoS settings for an interface:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 20 or Access the switch off-network and not
connected to the Internet on page 28.
The Device UI login page displays.