User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Routing User Manual254
Manually add an entry to the ARP table
You can manually add an entry to the ARP table.
To manually add an entry to the ARP table:
1. Connect your
computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ether
net cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 20 or Access the switch off-network and not
connected to the Internet on page 28.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 31.
4. Enter one of the following passwords:
• Enter your device admin password.
Port The associated interface of the connection.
MAC Address The unicast MAC address of the device. The address is six two-digit hexadecimal
numbers separated by colons, for example, 00:06:29:32:81:40.
Routing VLANs ARP Cache
IP Address The IP address. This must be the IP address of a device on a subnet attached to
one of the switch’
s existing routing interfaces.
Interface The routing interface associated with the
ARP entry.
MAC Address The unicast MAC address of the device. The address is six two-digit hexadecimal
numbers separated by colons, for example 00:06:29:32:81:40.
Type The type of ARP entry:
• Local.
An ARP entry associated with one of the switch’s routing interface’s
MAC
addresses.
• Gateway.
A
dynamic ARP entry for which the IP address is that of a router.
• Static. An ARP entry that was configured manually.
•
Dynamic. An
ARP entry that was learned by the switch.
Age The time in seconds since the entry was last refreshed in the ARP cache.
Table 54. ARP cache information (continued)
Field Description