User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Routing User Manual247
For information about the credentials, see Credentials for the device UI on page 29.
5. Click the Go
button.
The System Information page displays.
6. Select Routing> Router Discovery
> Router Discovery Configuration.
7. Select the check box for the VLAN routing interface.
8. From the Advertise Mode
menu, select Enable or Disable.
If you select Enable, router advertisements are transmitted from the selected interface.
9. In the Advertise Address
field, specify the IP address that must be advertised.
In the Maximum Advertise Interval field, enter the maximum time in seconds allowed
between router advertisements sent from the interface. The default value is 600.
10. In
the Minimum Advertise Interval field, enter the minimum time in seconds allowed
between router advertisements sent from the interface.
The value must be in the range of 3 to 1800. The default value is 450.
11. In the Advertise Lifetime
field, enter the value in seconds to be used as the lifetime field in
router advertisements sent from the interface.
This is the maximum length of time that the advertised addresses are to
be considered as
valid router addresses by hosts. The default value is 1800.
12. In the Preference Level
field, specify the preference level of the router as a default router
relative to other routers on the same subnet.
Higher numbered addresses are preferred. You must enter an integer
. The default value
is 0.
13. Click the Apply
button.
Your settings are saved.
Manage routes and view the routing table
The routing table collects routes from multiple sources: static routes and local routes. The
routing table can learn multiple routes to the same destination from multiple sources. The
routing table lists all routes.