User Manual

Table Of Contents
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual233
If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the device UI on page 29.
5. Click the Go
button.
The System Information page displays.
6. Select Switching > L2
Loop Protection > L2 Loop Protection Configuration.
7. Select whether to display physical interfaces, LAGs, or both by clicking one of the following
links above the table heading:
•1 (the
unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
LAG
. Only LAGs are displayed.
All. Both physical interfaces and LAGs are displayed.
8. Select
one or more interfaces by taking one of the following actions:
To configure a single interface, select the check box associated with the port, or type
the port number in the Go T
o Interface field and click the Go button.
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
To configure all interfaces with the same settings, select the check box in the heading
row
.
9. From the Keep Alive
menu, select Enable or Disable to specify whether keep-alives are
enabled on an interface.
The default is Enable.
10. From the RX Action
menu, select the action that occurs when the switch detects a loop on
an interface:
Log.
The switch logs a message.
Disable
. The switch disables the interface. This is the default action
.
Both. The switch both logs a message and disables the interface.
11. Click the Apply
button.
Your settings are saved.
12. Click the Clear button to
clear all the statistics in the table.