User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual224
The System Information page displays.
5. Select Switching> Multicast >
MLD Snooping > Querier Configuration.
6. Configure the following settings:
• Querier Admin Mode. Enable or
disable MLD snooping for the switch. The default is
Disable.
• Querier Address. Enter an IP address. This address specifies the snooping querier
address to be used as the source address in periodic MLD querie
s. This address is
used when no address is configured on the VLAN on which a query is being sent. The
supported IPv6 formats are x:x:x:x:x:x:x:x and x::x.
• MLD Version. Specify the MLD protocol version used in periodic MLD queries.
• Query Interval (secs).
Specify the
interval in seconds between periodic queries sent
by the snooping querier. The query interval must be a value in the range of 1 to 1800.
The default value is 60.
• Querier Expiry Interval (secs). Specify the interval in seconds after which the last
querier information is removed. The querier expiry interval must be a value in the
range of 60 to 300.
The default value is 60.
7. Click the Apply button.
Your settings are saved.
The page displays VLAN IDs enabled for the MLD snooping querier.
Configure the MLD snooping querier VLAN settings
To configure the MLD snooping querier VLAN settings:
1. Connect your computer
to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.