User Manual

Table Of Contents
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual145
To configure LAG settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch
a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page 20 or Access the switch off-network and not
connected to the Internet on page 28.
The Device UI login page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see
Register the switch on page 31.
4. Enter one of the following passwords:
Enter your device admin password.
If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network locat
ion.
For information about the credentials, see
Credentials for the device UI on page 29.
5. Click the Go
button.
The System Information page displays.
6. Select Switching> LAG >
Basic > LAG Configuration.
7. In the LAG Name field, enter a name for the LAG.
You can enter any string of up to 15 alphanumeric characters.
8. In the Description
field, enter the description string to be attached to a LAG.
The description can be up to 64 characters in length.
9. From the Admin Mode
menu, select Enable or Disable.
When the LAG is disabled, no traffic flows and LACPDUs are dropped, but the links that
form the LAG are not released. The default is Enable.
10. From the Hash Mode
menu, select the load-balancing mode for a port channel (LAG):
1 Src/Dest MAC, incoming port. This mode uses the source MAC address,
destination MAC address, and incoming port that are associated with the packet.