User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure System Information User Manual100
The range is 3,000–30,000 mW. The default is 30,000 mW.
13. From the Detection
Type menu, select how the port detects the attached PD:
• IEEE 802. The port performs a 4-point resistive detection.
This is the default setting.
• 4pt802.3af+legacy. The port performs a 4-point resistive detection, and if requi
red,
continues with legacy detection.
• Legacy. The port performs legacy detection.
14. From the T
imer Schedule menu, select a timer schedule or select None, which is the
default selection.
For information about setting up and configuring PoE timer schedules, see
Set up PoE
timer schedules on page 132.
15. Click the Apply
button.
Your settings are saved.
The following table describes the nonconfigurable fields on the page.
Table 22. PoE Port Configuration
Field Description
High Power All ports supports high power mode.
Power Limit (mW) The maximum power in milliwatts that can be provided by the port.
Class The class defines the range of power that a powered device (PD) is drawing from
the switch.
The class definitions are as follows:
•
0:
0.44–16.2W
•
1: 0.44–4.2W
•
2: 0.44–7.4W
•
3: 0.44–16.2W
•
4: 0.44–31.6W
•
Unknown. The
class cannot be detected, or no PD is attached to the port.
Output Voltage (Volts) The voltage that is delivered to the PD in volts.
Output Current (mA) The current that is delivered to the PD in mA.
Output Power (mW) The power that is delivered to the PD in milliwatts.
Status The operational status of the port:
• Disabled.
No
power is delivered.
• Delivering Power. Power
is being drawn by the PD.
• Requesting Power. The
port is requesting power.
• Fault. A problem occurred with the power.
•
Searching. The
port is not in one of the other states in this list.