Quick Start Manual

Introduction

NETGEAR GS110T Smart Switch

Ethernet, or Gigabit Ethernet devices. In addition, all RJ-45 ports operate in half-duplex or

full-duplex mode. The maximum segment length is 328 feet (100 meters) over Category 5

Unshielded Twisted-Pair (UTP) cable.

Features

The following list identifies the key features of the GS110T Smart Switch:

• Eight RJ-45 10/100/1000 Mbps autosensing Gigabit Ethernet switching ports.

• Two 1000M SFP Gigabit Ethernet switching ports.

• Full NETGEAR Smart Switch functionality.

• Full compatibility with IEEE standards:

• IEEE 802.3 CSMA/CD

• IEEE 802.3i (10BASE-T)

• IEEE 802.3u (100BASE-TX)

• IEEE 802.3x (Full-duplex flow control)

• IEEE 802.3ab (1000BASE-T)

• IEEE 802.3z (1000BASE-x)

• Autosensing and auto-negotiating capabilities for all ports.

• Auto Uplink™ on all ports to make the right connection.

• Automatic address learning function to build the packet-forwarding information table. The

table contains up to 4K Media Access Control (MAC) addresses.

• Store-and-Forward transmission to remove bad packets from the network.

• Full-duplex IEEE 802.3x pause frame flow control.

• Active flow control to minimize packet loss and frame drops.

• Half-duplex backpressure control.

• Per port LEDs, power LED.

• Standard NTGR 1xx series chassis.

• External 12V/1A Power Adapter.