User Manual
Table Of Contents
- Contents
- 1. Hardware Overview of the Switch
- 2. Install and Access the Switch in Your Network
- 3. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage the power saving mode
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Return the switch to its factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- B. Mount the Switch
Front panel
Figure 2. Front panel
The following table lists the front panel components from left to right.
Table 1. Front panel components
DescriptionLetter
Power LEDA
Factory Defaults button (see Use the Factory Defaults button to reset the switch on page 64)B
Eight RJ-45 Gigabit Ethernet ports numbered 1 through 8 that support 1G, 100M, and 10MC
Two RJ-45 10-Gig/Multi-Gig Ethernet ports numbered 9 and 10 that support 10G, 5G, 2.5G, 1G,
and 100M
D
For information about the status LEDs, see Status LEDs on page 10.
User Manual9Hardware Overview of the
Switch
8-Port Gigabit Ethernet Plus Switch with 2-Port 10G/Multi-Gig Uplinks GS110EMX