User Manual
Table Of Contents
- Contents
- 1. Hardware Overview of the Switch
- 2. Install and Access the Switch in Your Network
- 3. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage the power saving mode
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Return the switch to its factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- B. Mount the Switch
Basic technical specifications
The following table shows the basic technical specifications of the switch.
For more specifications, see the data sheet that you can download by visiting
downloadcenter.netgear.com.
Table 7. Basic technical specifications
DescriptionFeature
IEEE 802.3 Ethernet
IEEE 802.3x Full-Duplex Flow Control
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.3bz 2.5GBASE-T and 5GBASE-T
IEEE 802.3an 10GBASE-T
IEEE 802.3i 10BASE-T
IEEE 802.3az Energy Efficient Ethernet (EEE)
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE standards
Eight RJ-45 ports (ports 1 through 8) that support 1000BASE-T, 100BASE-TX, or
10BASE-T
Two RJ-45 ports (ports 9 and 10) that support 10GBASE-T, 5GBASE-T, 2.5GBASE-T,
1000BASE-T, or 100BASE-TX
Network interfaces
For 100 Mbps, use a Category 5 (Cat 5) or higher rated cable.Network cable
For 1 Gbps, 2.5 Gbps, or 5 Gbps, use a Category 5e (Cat 5e) or higher rated cable.
For 10 Gbps for up to 55 meter (180 feet), use a Category 6 (Cat 6) or higher rated
cable.
For 10 Gbps for more than 55 meter (180 feet), use a Category 6A (Cat 6A) or higher
rated cable.
The power adapter is localized to the country of sale.
Output: 12V, 2.5A
Power adapter
15.6WMaximum power
consumption
9.29 x 4.02 x 1.06 in. (236 x 102 x 27 mm)Dimensions (W x D x H)
1.65 lb (0.75 kg)Weight
32º to 104ºF (0° to 40°C)Operating temperature
90% maximum relative humidity, noncondensingOperating humidity
10,000 ft (3,000 m) maximumOperating altitude
–4° to 158°F (–20º to 70ºC)Storage temperature
User Manual74Factory Default Settings and
Technical Specifications
8-Port Gigabit Ethernet Plus Switch with 2-Port 10G/Multi-Gig Uplinks GS110EMX