ProSAFE Plus Configuration Utility User Guide

Chapter 1: Getting Started | 9
ProSafe Unmanaged Plus Switch Configuration Utility User Guide
Default Settings
All ProSafe® Plus Switch features have default settings. You do not need to configure any
settings in order to use the ProSafe® Plus switches. The following table lists the default
values for switch settings. Shaded features are not configurable on all switches.
Tab Menu Feature Default Value
System Status
Switch Selection No switch selected
Names All names blank
Passwords “password” for all switches
Switch Information
DHCP Mode Enabled
IP Address 192.168.0.239
Subnet Mask 255.255.255.0
Gateway Address 192.168.0.254
Maintenance
Change Password All fields blank
Device Reboot Unchecked
Factory Default Unchecked
Firmware Upgrade Filename blank
Monitoring
Port Statistics 0
Mirroring Disabled
Cable Tester OK or No Cable for each port
MultiCast
IGMP Snooping Status Enabled
VLAN IDEnabled for IGMP Snooping 1 (not configurable until VLAN is enabled)
Validate IGMPv3 IP header Disabled
Block Unknown Multicast Address Enabled