5-Port Switch 10/100/1000 Mbps Gigabit Ethernet Installation Guide GS105
Introduction The NETGEAR® 5-Port Gigabit Ethernet Switch Model GS105 provides you with a low-cost, reliable, high-performance switch to connect up to five different Ethernet-enabled devices (such as computers, file servers and routers) at blazing Gigabit Ethenet speeds. 5 Model GS105 5-Port 10/100/1000 Mbps Gigabit Ethernet Switch The GS105 Gigabit Ethernet Switch enables you to build a small network that gives you 10, 100, or 1000 Mbps access to other devices on the network.
1 Unpack the Box and Verify the Contents 5 Model GS105 5-Port 10/100/1000 Mbps Gigabit Ethernet Switch Wall-mount hardware Installation guide, warranty card and Support information card Power adapter When you open the box, verify that you received everything.
2 Prepare to Install the Switch Decide where you want to place the switch. Find a flat horizontal surface — such as a table, desk or shelf. The switch comes with wall-mounting screws. You’re welcome to use the screws if you want to hang the switch in an open space on a wall. Make sure the selected location is: • Not in direct sunlight or near a heater or heating vent. • Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all sides of the switch.
3 Install the Switch and Connect the Other Devices Apple G4 PC with GA302T Adapter Gigabit Ethernet 10/100/1000 Mbps Gigabit Switch GS105 On=10M, Blink=ACT 1 Power 2 3 4 Server with GA622T Adapter 1000M DSL modem LOCAL 10/100M 100M 8 Auto Uplink 7 6 5 4 3 2 1 INTERNET 12VDC 1.2A OFF 5 Green=FDX, Yellow=COL 1 2 3 4 ON 5 GS105 5-Port 10/100/1000 Mbps Gigabit Ethernet Switch FVS318 ProSafe VPN Firewall 1. Place the switch on a flat surface or hook onto the screws. 2.
Troubleshooting The Power light is not lit The switch has no power. • Make sure the power cord is properly connected to the switch. Power • Make sure the power adapter is properly connected to a functioning power outlet. If it’s in a power strip, make sure the power strip is turned on. If the socket is controlled by a light switch, make sure the switch is in the on position. • Make sure you are using the NETGEAR power adapter supplied with your switch.
Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Technical Support PLEASE REFER TO THE SUPPORT INFORMATION CARD THAT SHIPPED WITH YOUR PRODUCT. By registering your product at www.NETGEAR.com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. NETGEAR, INC. Support Information Phone: 1-888-NETGEAR (For US & Canada only) - 24 x7 phone support See Support Information card for other countries. E-mail: support@NETGEAR.com (24 x 7 online support) www.NETGEAR.com ©2003 NETGEAR, Inc.
