GC728X-GC728XP-GC752X-GC752XP Hardware Installation Guide

SFP and SFP+ Ports for Fiber Connectivity
To enable fiber connections on the switch, SFP and SFP+ fiber ports accommodate standard small form-factor
pluggable (SFP) gigabit interface converters (GBICs, also referred to as transceiver modules). GBICs are
sold separately from the switch.
The switch supports the NETGEAR SFP and SFP+ transceiver modules that are listed in the following table.
Table 5. Supported SFP and SFP+ transceiver modules
DescriptionModelSpeed and Medium
SFP transceiver 1000BASE-SXAGM731F1G Ethernet short-reach fiber
SFP transceiver 1000BASE-LXAGM732F1G Ethernet long-reach fiber
SFP transceiver 1000BASE-TAGM7341G Ethernet copper
SFP+ transceiver 10GBASE-SR multimodeAXM76110GBASE short-reach fiber
SFP+ transceiver 10GBASE-LR single modeAXM76210GBASE long-range fiber
SFP+ transceiver 10GBASE-LRM
multimode
AXM76310GBASE long-range fiber
SFP+ transceiver 10GBASE-LR Lite single
mode
AXM76410GBASE long-range fiber lite
SFP+ Transceiver 10GBASE-TAXM76510GBASE copper
SFP+ DAC cable, 3 feet (1 meter)AXC76110G Ethernet copper
SFP+ DAC cable, 9 feet (3 meters)AXC76310G Ethernet copper
For more information about NETGEAR SFP and SFP+ transceiver modules, visit
netgear.com/business/products/switches/modules-accessories.
If you use a third-party passive direct-attach cable (DAC), the length of the cable must
not exceed 16.4 feet (5 meters).
Note
USB Port
The switch provides one USB 2.0 port that lets you upload firmware, upload or download (back up) the
configuration settings file, and download a memory dump (for debugging purposes) using a USB storage
device.
The USB storage device that you attach to the USB port must comply with the following requirements:
• The USB device must support USB 2.0.
• The USB device must support the FAT32 or VFAT file type.The NTFS file type is not supported.
Hardware Overview
17
Insight Managed 28-Port and 52-Port Gigabit Ethernet (PoE+) Smart Cloud Switch