User Manual
Table Of Contents
- Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
- Contents
- 1. Getting Started
- Switch Management Options and Default Management Mode
- Available Publications
- Web Browser Requirements and Supported Browsers
- User-Defined Fields
- Interface Naming Conventions
- Access the Switch
- Change the Management Mode of the Switch
- Register the Switch
- How to Configure Interface Settings
- Local Browser Interface Device View
- 2. Configure System Information
- View and Configure the Switch Management Settings
- View or Define System Information
- View the Switch CPU Status
- Configure the CPU Thresholds
- Configure the IPv4 Address for the Network Interface and Management VLAN
- Configure the IPv6 Address for the Network Interface
- View the IPv6 Network Neighbor
- Configure the Time Settings
- Configure Denial of Service Settings
- Configure DNS Settings
- Configure Green Ethernet Settings
- Manage the Bonjour Settings and View Bonjour Information
- Control the LEDs
- Use the Device View
- Configure Power over Ethernet
- Configure Link Layer Discovery Protocol
- Configure DHCP L2 Relay and DHCP Snooping
- Set Up PoE Timer Schedules
- View and Configure the Switch Management Settings
- 3. Configure Switching
- 4. Configuring Routing
- 5. Configure Quality of Service
- 6. Manage Device Security
- Management Security Settings
- Configure Management Access
- Configure Port Authentication
- Set Up Traffic Control
- Configure Access Control Lists
- Use the ACL Wizard to Create a Simple ACL
- Configure a Basic MAC ACL
- Configure MAC ACL Rules
- Configure MAC Bindings
- View or Delete MAC ACL Bindings in the MAC Binding Table
- Configure an IP ACL
- Configure Rules for a Basic IP ACL
- Configure Rules for an Extended IP ACL
- Configure an IPv6 ACL
- Configure Rules for an IPv6 ACL
- Configure IP ACL Interface Bindings
- View or Delete IP ACL Bindings in the IP ACL Binding Table
- Configure VLAN ACL Bindings
- 7. Perform Maintenance Tasks
- 8. Manage Power over Ethernet
- 9. Monitor the System
- A. Configuration Examples
- B. Hardware Specifications and Default Values
Hardware Specifications and Default Values
413
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
Interface
Trust Mode 802.1p
Interface Shaping Rate 0
802.1p to Queue Mapping (802.1p –> Queue) 0 -> 1
1 -> 0
2 -> 0
3 -> 1
4 -> 2
5 -> 2
6 -> 3
7 -> 3
Queue Minimum Band Width 0
Queue Scheduler Type Weighted
Auto-VoIP Protocol-based
Admin Mode Disabled
Prioritization Type Traffic Class
Traffic Class 3
Auto-VoIP OUI-based
Admin Mode Disabled
Auto-VoIP VLAN 2
OUI-based priority 7
Table 94. Port characteristics
Feature Sets Supported Default
Auto negotiating speed and
full/half duplex
All ports Auto negotiation
Auto MDI/MDIX for cross over cables on all ports Enabled
802.3x flow control/back pressure 1 (per system) Disabled
Port mirroring: TX, RX, Both 4 Disabled
Port trunking (aggregation) 5 Pre-configured
802.1D spanning tree 1 Disabled
802.1w RSTP 1 Enabled
802.1s spanning tree 24 and 8 MST instances Disabled
Table 93. Feature Default Values and Default State (continued)
Feature Name/Parameter Default