User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure System Information User Manual51
of the port to be connected in that management VLAN must be the same as the
management VLAN ID.
Note: Make sure that the VLAN that you want to assign as the management
VLAN exists. Also make sure that the PVID of at least one port in the
VLAN is the same as the management VLAN ID. For information about
creating VLANs and configuring the PVID for a port, see
Configure
VLANs on page 121.
10. Click the Apply button.
Your settings are saved.
Configure the IPv6 network settings for the local browser
interface
You can configure IPv6 network information for the local browser UI, which is the logical
interface used for in-band connectivity with the switch through any of the switch’s front-panel
ports.
To access the switch over an IPv6 network, you must initially configure the switch with IPv6
information (an IPv6 prefix, prefix length, and default gateway). You can configure IPv6 using
one of the following options:
• IPv6 auto-configuration
• DHCPv6
When in-band connectivity is established, IPv6 information can be changed using
SNMP-based management or web-based management.
To configure the IPv6 network settings for the local browser UI:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
For information about finding the IP address of the switch, see Access the switch on
page 14.
The Local Device Login page displays.
If you did not yet register the switch with your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register and access the switch with
your NETGEAR account on page 29.