User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Monitor the Switch User Manual444
7. Select an Admin Mode radio button:
• Disable. Port mirroring is disabled. This is the default setting.
• Enabled. Port mirroring is enabled.
8. From the Destination Port menu, select the destination port to which port traffic must be
copied.
You can configure only one destination port on the system. The port functions as a probe
port and receives traffic from all configured source ports. If no port is configured, None is
displayed. The default is None.
Perform the following steps in the Source Interface Configuration section.
9. Select whether to display physical interfaces, LAGs, the CPU, or al by clicking one of the
following links above the table header:
•1 (the unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
• LAG. Only LAGs are displayed.
• CPU. Only the CPU is displayed.
• All. The physical interfaces, LAGs, and CPU are displayed.
10. Select one or more interfaces by taking one of the following actions:
• To select a single interface, select the check box associated with the port, or type the
port number in the Go To Interface field and click the Go button.
• To select multiple interfaces, select the check box associated with each interface.
• To configure all interfaces with the same settings, select the check box in the table
header.
Traffic from the selected ports will be sent to the destination port.
11. From the Direction menu, specify the direction of the traffic that must be mirrored from the
selected source ports:
• None. The value is not configured. This is the default setting.
• Tx and Rx. Monitors transmitted and received packets.
•Rx. Monitors received (ingress) packets only.
•Tx. Monitors transmitted (egress) packets only.
12. Click the Apply button.
Your settings are saved.
The Status field indicates the interface status. The destination port is listed as Probe. The
source ports are listed as Mirrored.