User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Manage Switch Security User Manual311
• To configure all interfaces with the same settings, select the check box in the
table header.
b. If the selection from the Ingress Control Mode menu is not Disabled, specify
whether the ingress control mode is enabled by selecting Enable or Disable from
the Status menu in the table header.
c. In the Threshold field in the table header, specify the maximum rate at which
unknown packets are forwarded.
The range is a percent of the total threshold between 0–100 percent. The default is
5
percent.
d. From the Control Action mode menu in the table header, select one of the following
options:
• None. This is the default setting.
• Trap. If the threshold of the configured broadcast storm is exceeded, a trap is
sent.
• Shutdown. If the threshold of the configured broadcast storm is exceeded, the
port is shut down.
10. Click the Apply button.
Your settings are saved.
Configure port security
Port security lets you lock one or more ports on the switch. When a port is locked, only
packets with an allowable source MAC addresses can be forwarded. All other packets are
discarded.
Configure the global port security mode
To configure the global port security mode:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
For information about finding the IP address of the switch, see Access the switch on
page 14.
The Local Device Login page displays.
If you did not yet register the switch with your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register and access the switch with
your NETGEAR account on page 29.