User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Getting Started User Manual29
the switch is registered only after you access the switch local browser UI with your
NETGEAR account. After you do so, you can access the local browser UI with the local
device password.
The following table lists the essential credential options for access to the local browser UI.
Table 2. Credentials for access to the local browser UI
Management mode Registered Added to an
Insight network
Credentials Local browser UI
menu
Default mode:
NETGEAR Insight Mobile
App and Insight Cloud
Portal (Cloud/Remote)
No N/A Local device password Limited menu
Yes No Local device password Limited menu
Yes Yes Insight network password Limited menu
Direct Connect
W
eb-browser Interface
(Local LAN Only)
No N/A Local device password Limited menu
Yes No Local device password Full menu
Yes Yes Insight network password Full menu
Note: The default local device password is password. The first time that you
enter the default local device password, the Change Default
Password page displays, requiring you to customize the local device
password. To change the password again, see
Change the local
device password for the local browser UI on page 264.
Register and access the switch with your
NETGEAR account
Note: If you already registered the switch and accessed the switch local browser
UI with your NETGEAR account, you can skip this section.
You only need to register the switch and access the switch local browser UI once with your
NETGEAR account credentials.
Note: If you reset the switch to factory default settings, the first time that you
access the switch local browser UI, you must again provide your
NETGEAR account credentials.