User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure Quality of Service User Manual255
This is an integer value in the range 0 to 7.
12. Configure the policy attributes:
• Drop. Select this radio button to require each inbound packet to be dropped.
• Mark VLAN CoS. Select this radio button to specify the VLAN priority, which you must
select from the menu. The VLAN priority is expressed as an integer value in the range
from 0 to 7.
• Mark IP Precedence. Select this radio button to require packets to be marked with an
IP precedence value before being forwarded. You must select an IP precedence
value from 0 to 7 from the menu.
• Mirror. Select this radio button to require packets to be mirrored to an interface or
LAG, one of which you must select from the menu.
• Redirect. Select this radio button to require packets to be redirected to an interface or
LAG, one of which you must select from the menu.
• Mark IP DSCP. Select this radio button to require packet to be marked with an IP
DSCP keyword code, which you must select from the menu. The menu includes
Other as a selection, which lets you enter an IP DSCP value from 0 to 63. The DSCP
value is defined as the high-order 6 bits of the Service Type octet in the IP header.
• Simple Policy. Select this radio button to define the traffic policing style for the class.
A simple policy uses a single data rate and burst size, resulting in one of two
outcomes: conform or violate. You must define the policy as described in the next
step.
13. If you select the Simple Policy radio button, you can specify the traffic policing style for the
class:
• Color Blind. This is the default selection. Color classes are not supported.
• Committed Rate. Enter the committed rate that is applied to conforming packets by
specifying a value in the range from 1 to 4294967295 Kbps.
14. Select the conforming and violating actions.
The Conform Action section and Violate Action section list the actions to be taken on
conforming packets according to the policing metrics. By default, both conforming
packets and violating packets are sent.
In both the Conform Action section and the Violate Action section, select one of the
following actions:
• Send. Packets are forwarded unmodified. This is the default confirming action and the
default violating action.
• Drop. Packets are dropped.
15. Click the Apply button.
Your settings are saved.