User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configuring Routing User Manual226
The System Information page displays.
6. Select Routing > ARP > Advanced > ARP Create.
The Static ARP Configuration page displays. The page also shows the Routing VLANs
ARP Cache section.
7. In the IP Address field, specify the IP address to add.
The address must be the IP address of a device on a subnet attached to one of the
switch’s existing routing interfaces.
8. In the MAC Address field, specify the unicast MAC address of the device.
The format is six 2-digit hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
9. Click the Add button.
The entry is added to the table.
10. To refresh the page with the latest information about the switch, click the Refresh button.
For information about the information in the Routing VLANs ARP Cache table, see Table 51,
ARP cache information for routing VLANs on page 225.
Configure the global ARP settings
You can display and change the configuration settings for the ARP table.
To display or change the setting for the ARP table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
For information about finding the IP address of the switch, see Access the switch on
page 14.
The Local Device Login page displays.
If you did not yet register the switch with your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register and access the switch with
your NETGEAR account on page 29.
4. Enter one of the following passwords:
• After registration, enter your customized local device password.
• If you previously added the switch to an Insight network location, enter the Insight
network password.