User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure Switching User Manual197
7. Select whether to display physical interfaces, LAGs, or both by clicking one of the following
links above the table header:
•1 (the unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
• LAG. Only LAGs are displayed.
• All. Both physical interfaces and LAGs are displayed.
8. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the table
header.
9. From the Admin Mode menu, specify whether MVR is enabled for the interface by selecting
Enable or Disable.
The default is Disable.
10. From the Type menu, specify whether the port is an MVR receiver or an MVR source by
selecting receiver or a source.
The default port type is none.
11. From the Immediate Leave menu, specify whether the Immediate Leave feature is enabled
by selecting Enable or Disable.
The default is Disable.
12. Click the Apply button.
Your settings are saved.
The status field displays the status of each MVR interface.
Configure the MVR group membership
To configure the MVR group membership:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
For information about finding the IP address of the switch, see Access the switch on
page 14.
The Local Device Login page displays.