User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure Switching User Manual196
This entry in this field lets you create multiple MVR groups through a single click of the
Add button. If the field is empty, clicking the Add button creates one new group only. The
range is from 1 to 256. By default, the field is blank.
9. Click the Add button.
The MVR group or groups are added.
The following table describes the nonconfigurable information displayed on the page.
Table 42. MVR Group Configuration
Field Definition
Status The status of the specific MVR group.
Members The list of ports that participate in the specific MVR group.
Configure an MVR interface
To configure an MVR interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
For information about finding the IP address of the switch, see
Access the switch on
page 14.
The Local Device Login page displays.
If you did not yet register the switch with your NETGEAR account, the Register to unlock
all features page displays. For more information, see
Register and access the switch with
your NETGEAR account on page 29.
4. Enter one of the following passwords:
• After registration, enter your customized local device password.
• If you previously added the switch to an Insight network location, enter the Insight
network password.
For more information about the local device password and the Insight network password,
see
Credentials for the local browser UI on page 28.
5. Click the Login button.
The System Information page displays.
6. Select Switching > MVR >
Advanced > MVR Interface Configuration.
The MVR Interface Configuration page displays.