User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure Switching User Manual161
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the table
header.
10. Configure the MST values for the selected interfaces:
• Port Priority. The priority for a particular port within the selected MST instance. The
port priority is set in multiples of 16. If you specify a value that is not a multiple of 16,
the priority is set to the priority is automatically set to the next lowest priority that is a
multiple of 16. For example, if you set a value between 0 and 15, the priority is set to
0. If you specify a number between 16 and 31, the priority is set to 16. Specify a value
in the range of 0–240. By default, the value is 128.
• Port Path Cost. Set the path cost to a new value for the specified port in the selected
MST instance. Specify a value in the range of 0–200000000. By default, the value
is
0.
11. Click the Apply button.
Your settings are saved.
12. To refresh the page with the latest information about the switch, click the Refresh button.
The following table describes the read-only MST port configuration information displayed on
the Spanning Tree CST Configuration page.
Table 32. MST port status information
Field Description
Operational Port Path Cost The operational path cost for the port in the MST instance.
Auto-calculated Port Path
Cost
Indicates whether the path cost is automatically calculated (Enabled) or not
(Disabled). If the configured value for the port path cost is zero, the path cost is
calculated based on the link speed of the port.
Port ID The port identifier for the specified port within the selected MST instance. It is
made up from the port priority and the interface number of the port.
Port Up Time Since Counters
Last Cleared
The time since the counters were last cleared, displayed in days, hours,
minutes, and seconds.
Port Mode The Spanning Tree Protocol administrative mode that is associated with the port
or port channel. The possible values are Enable and Disable.