User Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power
Configure Switching User Manual114
• LAG. Only LAGs are displayed.
• All. Both physical interfaces and LAGs are displayed.
9. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the table
header.
10. In the Description field, enter the description string to be attached to a port.
The string can be up to 64 characters in length.
11. From the Admin Mode menu, select Enable or Disable.
This sets the port control administrative mode. You must select Enable in order for the
port to participate in the network. The default is Enable.
12. From the Autonegotiation menu, select Enable or Disable.
This specifies the autonegotiation mode for this port. The default is Enable.
Note: After you change the autonegotiation mode, the switch might be
inaccessible for a number of seconds while the new settings take
effect.
13. In the Speed field, specify the speed value for the selected port.
- Auto. All supported speeds. If you select Auto, the duplex mode and speed are
set by the autonegotiation process. The port’s maximum capability (full duplex
and 1000 Mbps) are advertised. Otherwise, your selection determines the port’s
duplex mode and transmission rate. The default setting is Auto.
-10. 10 Mbits/sec.
- 100. 100 Mbits/sec.
- 1000. 1000 Mbits/sec. This selection is available only if autonegotiation is
enabled.
The delimiter characters for setting different speed values are a comma (,), a period
(.) and a space ( ). For you to set the auto-negotiation speed, the autonegotiation
mode must be set to Enable. The default is Auto.
Note: After you change the speed settings, the switch might be inaccessible
for a number of seconds while the new settings take effect.
14. From the Duplex Mode menu, select the duplex mode for the selected port.
Possible values are as follows:
• Auto. Indicates that speed is set by the auto-negotiation process.
• Full. Indicates that the interface supports transmission between the devices in both
directions simultaneously.