User's Manual Part 3
Table Of Contents
- Chapter 9 Maintenance
- Chapter 10 Advanced Configuration
- Chapter 11 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Networks, Routing, and Firewall Basics
- Appendix C Preparing Your Network
- Appendix D Firewall Log Formats
- Appendix E Wireless Networking Basics
- Appendix F Virtual Private Networking
- Appendix G NETGEAR VPN Configuration FVS318 or FVM318 to FWG114P
- Appendix H NETGEAR VPN Configuration FVS318 or FVM318 with FQDN to FVS328
- Glossary
- Index
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
8-46 Virtual Private Networking
March 2004, 202-10027-01
To test the connection to a computer connected to the FWG114P, simply ping the IP address of
that computer.
Once connected, you can open a browser on the remote PC and enter the LAN IP Address of the
FWG114P, which is http://192.168.0.1 in this example. After a short wait, you should see the login
screen of the FWG114P.
From the FWG114P to the Client PC
You can use the FWG114P Diagnostic utilities to test the VPN connection from the FWG114P to
the client PC. Run ping tests from the Diagnostics link of the FWG114P main menu.
Monitoring the PC VPN Connection
Information on the progress and status of the VPN client connection can be viewed by opening the
Netgear ProSafe VPN Client Connection Monitor or Log Viewer. To launch these functions, click
on the Windows Start button, then select Programs, then Netgear ProSafe VPN Client, then either
the Connection Monitor or Log Viewer.
The Log Viewer screen for a successful connection is similar to the one shown below:
Figure 8-34: Log Viewer screen